DIY


Here's a few tips for your build:

Artwork:

Download Artwork Templates (PSD Format)

General Tips:

- Avoid Using Electric drills / screw drivers when screwing down your plexi, joystick, and back cover as they can strip or drill through the screw holes. DO NOT OVER TIGHTEN THE SCREWS.

- Have Fun & Take your time!

Joystick:

-Uses the Sanwa JLF Joysticks with Flat Mounting plate such as:

http://arcadeshock.com/collections/sanwa-denshi/products/sanwa-denshi-joystick-w-base-harness-jlf-tp-8yt-sk-

Seimitsu joysticks with the "MS" style plate & Hori Hayabusa joysticks will work but may require modifications to fit due to height clearance.

Buttons:

- Top: Fits 30mm Japanese style SNAP-IN buttons (Sanwa, Seimitsu, Hori, Gamerfinger, etc). *Sanwa Screw-In buttons will also work but require using Seimistu screw button nuts.

- Back: Use 24mm Japanese style SCREW-IN buttons

USB Port:

You'll need to install a Neutrik USB feed-through port in the extra 24mm hole in the back.

https://www.focusattack.com/neutrik-nausb-w-a-b-usb-feed-through-silver/

PCBs:

Recommended PCBs:

PS4 / PS3 / PC / XBOXONE / XBOX360 / WIIU - Brook Universal Fighting Board

http://www.paradisearcadeshop.com/home/1658-brook-universal-fighting-board-ps3-ps4-xbox-360-xbox-one-pc-.html?search_query=Brook&results=20

PS4 / PS3 / PC - Brook Fightboard

http://www.paradisearcadeshop.com/fgc-console-joystick/1660-brook-ps3ps4-fighting-board-with-paradise-breakout-.html?search_query=Brook&results=20

Keep your Firmware Updated for Brook PCBs:

http://www.brookaccessory.com/download

I also recommend buying adhesive PCB Feet such as these to make mounting the pcb easy:

https://www.focusattack.com/ez-snap-low-profile-adhesive-pcb-feet/

Painting Tips:

Sand case with 400 grit (or more) sandpaper until smooth.

Roll or spray on 1 coat of Primer, allow to dry

Sand until smooth, wipe off any access debris, repeat with additional coast if necessary.

Roll or spray on your paint color. If using spray paint, follow the directions on the can (spray in one direction, in thin coats, stay at least 12" away while spraying). Allow to fully dry. Sand to smooth any rough areas. Use higher grit sandpaper in between coats to achieve a smooth finish. Wipe off any debris. Repeat for 3 additional coats or until satisfied.

Recommended Stores Arcade Parts stores:

www.paradisearcadeshop.com

www.arcadeshock.com

www.focusattack.com

www.jasenscustoms.com

Recommended Advanced Modders:

VickoMods

Gummo

Looking for more Case options? Check out my Friends:


Jasen's Customs

FoeHammer

Anomaly

B15SDM

Can't wait to see what you guys do with your cases. Please share your completed work with me!